Beretta® PX4 Spurless Hammer

Installation with the help of Mr. Langdon's video was a breeze. I'm very pleased with the appearance as well as the conceal-ability of my PX4 Subcompact. Thanks LTT.

Fits great, looks great. Gives that extra assurance that you'll have less chance of printing or snagging on your clothes. Everything from LLT is great, I just wish I would have known about you guys ling ago as I've primarily made all of my purchases from Beretta USA for all of my upgrades.

Ps, please make available the trigger bar for separate purchase.

Great addition! Makes CC with no printing. Presents a nice low profile. I’m pleased with LTT products/additions

If you want to finish snag proofing a Compact Carry you should to install the Spurless Hammer.

The fit & finish is top notch. You can expect a flush fit to the back of the slide. I ordered black and it is an exact match to the other black items on the pistol.

Install is not difficult if you have prior gunsmith experience. If you do not, pay special attention to the hammer retaining pin as it is easy to lose. Also, use videos on YouTube associated with a PX4 trigger bar replacement to assist you in returning the trigger group to the trigger bar.

Best of luck and enjoy!

Purchased the spurless hammer for my LTT PX4 Carry. Installation was a snap with Ernest's video on the how to install it. I love the slight but noticeable reduction in printing (for me) when I carry the pistol Appendix. Ernest and Aimee as always were great with communication and they even did a little polishing on the hammer to match up with the Langdon trigger job I had done on the pistol.

Yet another great part for your PX4 from LTT!

Loving my PX4CC but having a high grip I got several hammer bites! This spurless hammer is the best adition to make a great gun even greater. Thanks LTT!

Utilizing a high grip on the PX4 compact carry can result in hammer bite. There's a LTT YouTube video that covers the installation of the Spurless hammer and is very easy to install. I'll also add that polishing up the NP3 is very easy. The Spurless hammer eliminates the hammer bite and is tastefully done. It's a must have for those of us gripping the PX4 high.

This hammer went onto a used PX4 subcompact I bought as a test mule for the platform. It cleaned up the DA pull, reduced stacking and deleted the spur--after carrying daily for over four decades I either buy bobbed hammers or get out the Dremel.

Swapped this into my PX4 Compact Carry, it's great modification for a carry gun, nice feeling having your thumb firmly on the back of the slide while re-holstering, and cleaner for concealment. Ran 50 rounds through it, no difference in the trigger before and after, great as ever.

It was relatively easy using Ernest's youtube video, my holder punch was a little deep for the roll pin, but I made it work by putting a a small piece of paper clip in the punch 1st, then the roll pin. Would be hard without the holder punch, great tip!