Ameriglo Sight Set - PX4 Full Size and Sub-Compact
Ameriglo Sight Set
These Sights will work on the PX4 Full Size and PX4 Sub-Compact.
Front height .257" width .144"
Rear height .320" width .150"
7 Reviews Hide Reviews Reviews
These are the same basic sights that came on my compact carry. So naturally I bought them for the full size px4 that i purchased at a heck of a bargain. Sight seem nice but the only down fall is I now have to buy a sight pusher to get the rear sight the last 1/16th of an inch. I can not move it with my plastic drift punch, front sight went on great
I already have a set on my full size PX4 adding these to my sub-compact. Can't say enough how great it is having Langdon Tactical out there for Beretta pistols
Great Price Great Product
I would highly recommend these sights for your Beretta PX4 full-size and sub-compact. Went right on without a problem. Match up perfectly with the factory sights.
This works on the PX4 SubCompact as well. Had them installed and they work great. When combined with the stealth lever kit, a high mag release button, talon grips, a cerakoted slide and a lower-weight hammer spring, makes a nice little brother to the PX4 Compact Carry.
I'm 66 and have the normal amount of difficulty of someone of my age in focusing on the front sight. The combination of the big red/orange square front and adequate clearance on either side of it from the plain black rear make getting a solid sight picture possible again. The sights are never going to be as sharp as they were when I was younger, but these are close.
These sights also took care of an issue I had with the original sights causing low hits on my F model, elevation is dead on with the Ameriglos.
I liked the set on my F model so much that when I acquired a D model, I had LTT install them on its slide with the same great results!